Table 5.5 Information to be read by IDENTIFY DEVICE command (5 of 5)

*20 Word 93: CBLID– detection results

Hardware reset result. The contents of bits 12-0 of this word shall change only during the execution of a hardware reset.

Bit 15: Shall be cleared to zero

Bit 14: Shall be set to one

Bit 13: 1=Device detected CBLID– above VIH 0=Device detected CBLID– below VIL

Bit 12-8: Device 1 hardware reset result. Device 0 shall clear these bits to zero Device 1 shall set these bits as follows:

Bit 12: Reserved

Bit 11: 0=Device 1 did not assert PDIAG– 1=Device 1 asserted PDIAG–

Bit 10-9: These bits indicate how Device 1 determined the device number: 00=Reserved

01=a jumper was used 10=the CSEL signal was used

11=some other method was used or the method is unknown

Bit 8: Shall be set to one

Bit 7-0: Device 0 hardware reset result. Device 1 shall clear these bits to zero Device 0 shall set these bits as follows:

Bit 7: Reserved

Bit 6: 0=Device 0 does not respond when Device 1 is selected 1=Device 0 responds when Device 1 is selected.

Bit 5: 0=Device 0 did not detect the assertion of DASP– 1=Device 0 detected the assertion of DASP–

Bit 4: 0=Device 0 did not detect the assertion of PDIAG– 1=Device 0 detected the assertion of PDIAG–

Bit 3: 0=Device 0 failed diagnostics 1=Device 0 passed diagnostics

Bit 2-1: These bits indicate how Device 0 determined the device number: 00=Reserved

01=a jumper was used 10=the CSEL signal was used

11=some other method was used or the method is unknown

Bit 0: Shall be set to one

*21 Word 128: Security status

Bit 15-9: Reserved

Bit 8: Security level 0=High, 1=Maximum

Bit 7-6: Reserved

Bit 5: 1=Enhanced security erase supported

Bit 4: 1=Security count expired

Bit 3: 1=Security frozen

Bit 2: 1=Security locked

Bit 1: 1=Security enabled

Bit 0: 1=Security supported

5 - 34

C141-E099-01EN

Page 99
Image 99
Fujitsu MPF3XXXAT manual Information to be read by Identify Device command 5