Fujitsu P2000 manual Installing a Memory Upgrade Module

L i f e B o o k P 2 0 0 0 N o t e b o o k – S e c t i o n F o u r

Memory Upgrade

Module

Your Fujitsu LifeBook notebook comes with 256MB of on-board high speed Synchronous Dynamic RAM (SDRAM) factory installed. To increase your LifeBook notebook’s memory capacity, you may install an addi- tional memory upgrade module. The memory upgrade must be a dual-in-line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from the Fujitsu web store at www.fujitsupc.com.

C A U T I O N

The memory upgrade module can be severely damaged by electrostatic discharge (ESD). Be sure you are properly grounded when handling and installing the module.

INSTALLING A MEMORY UPGRADE MODULE

To install a memory upgrade module follow these steps:

W A R N I N G

You must turn off power and remove any modem connection before installing the memory upgrade module.

1.Turn off power to your LifeBook notebook, and remove any power adapter (AC or auto/airline), battery pack, and modem connection.

2.Place your LifeBook notebook with the bottom facing up on a clean work surface.

3.Using a Phillips screwdriver, remove the screw from the hole indicated. (Figure 4-3)

Figure 4-3 Removing screw from bottom

4.Turn the system over and open the top cover all the way, so that it is lying flat on the work surface.

5.Pry the spacer panel in front of the keyboard away from the system. (Figure 4-4)

Spacer panel

Figure 4-4 Lifting the spacer panel

6.Slide the keyboard forward slightly until it disen- gages and can be lifted freely. (Figure 4-5)

Figure 4-5 Sliding the keyboard

C A U T I O N

Be very careful when pivoting the keyboard below. The keyboard is connected with fragile flat cables.

7.Carefully pivot the front of the keyboard away from the laptop until it is lying on the display.

(Figure 4-6)

Figure 4-6 Folding the keyboard back

40