Fujitsu P2000 manual Memory Problems, Modem Problems, USB Device Problems

L i f e B o o k P 2 0 0 0 N o t e b o o k – S e c t i o n S i x

Problem	Possible Cause	Possible Solutions
You have connected an	Your operating system	Check your device and operating system
external keyboard or a	software is not setup with	documentation and activate the proper driver.
mouse and it seems to be	the correct software driver
locking up the system.	for that device.
	Your system has crashed.	Try to restart your notebook. If that fails, turn off
		the power using the Power Off button located on the
		back of the system. Wait 10 seconds or more, and
		then turn the system back on.
When the system is slightly	This happens due to the design	If this occurs, wait until the cursor stops moving; it
inclined and the Quick-	specifications of the Quick	should then work properly.
Point device has been	Point device.
worked with slowly for
several seconds, the cursor
slowly moves across the
screen when you are not
using it.
Memory Problems
Your Power On screen, or	Your memory upgrade module	Remove and re-install your memory upgrade
Main menu of the BIOS	is not properly installed.	module. (See Memory Upgrade Module on page 40
setup utility information,		for more information)
does not show the correct
	You have a memory failure.	Check for Power On Self Test (POST) messages.
amount of installed
		(See Power On Self Test Messages on page 74 for more
memory.
		information)
Modem Problems
Messages about modem	Messages about modem	See your application software documentation for
operation.	operation are generated by	additional information.
	whichever modem application
	is in use.
USB Device Problems
You have installed a USB	The device is not properly	Remove and re-install the device. (See Device Ports
device but your LifeBook	installed.	on page 43 for more information)
notebook does not recog-
	The device may have been	Close the application and restart your notebook.
nize the device, or the
	installed while an application
device does not seem to
	was running, so your notebook
work properly.
	is not aware of its installation.
	Your software may not have	See your software documentation and activate the
	the correct software driver	correct driver.
	active.
	You may have the wrong I/O	See your device documentation and software docu-
	address selected for your	mentation to determine the required I/O address.
	device.	Change the settings in the BIOS setup utility. (See
		BIOS Setup Utility on page 27 for more information)
	Your device and another	Check all I/O addresses located within the BIOS
	device are assigned the same	setup utility and any other installed hardware or
	I/O address.	software to make sure there are no duplications.

68