Fujitsu P2000 manual Removing a Memory Upgrade Module

8.Align the connector edge of the memory upgrade module, chip side up, with the connector slot in the compartment. (Figure 4-7)

Figure 4-7 Inserting a new memory module

9.Insert the memory upgrade module at a 45o angle and press it firmly onto the connector.

10.Press the memory upgrade module down into the compartment until it locks underneath the retaining clip. You will hear a click when it is properly in place. (Figure 4-7)

11.Carefully flip the keyboard back into its original position, and slide it towards the front of the unit until it is seated. (Figure 4-8)

U s e r I n s t a l l a b l e F e a t u r e s

P O I N T

The memory upgrade module is not something you routinely remove from your LifeBook notebook. Once it is installed, you should leave it in place unless you want to increase system memory capacity.

REMOVING A MEMORY UPGRADE MODULE

1.Perform steps 1 through 7 of Installing a Memory Upgrade Module.

2.Pull the clips sideways away from each side of the memory upgrade module at the same time. (Figure 4-10)

Figure 4-8 Reinstalling the keyboard

12.Replace the spacer panel you removed in step 4. (Figure 4-9)Installation of the new memory module is now complete.

Figure 4-9 Replacing the spacer panel

13. Replace the screw you removed in step 3.

Figure 4-10 Removing a memory module

3.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the back of your LifeBook notebook.

4.Store the memory upgrade module in a static guarded sleeve.

5.Replace the keyboard by following steps 10 and 11 of Installing a Memory Upgrade Module.

CHECKING THE COMPUTER RECOGNITION OF NEW MEMORY CAPACITY

Once you have changed the system memory capacity by either adding or removing a memory upgrade module, be sure to check that your LifeBook notebook has recognized the change.

You can check the memory capacity by looking at the main menu of the BIOS setup:

1.Turn on the power to your LifeBook notebook using the power switch.

2.Allow the system to start booting and press the F2 key once the Fujitsu logo appears on the screen. This will open the main menu of the BIOS setup with the current settings displayed. (See BIOS Setup Utility on page 27 for more information) Use the right arrow key to select Info in the BIOS Setup menu.

41