Furuno 1734C manual Erasing track, Track memory window, Erasing own ship track by area, Erase menu

3. PLOTTER OPERATION

3. Press the EDIT soft key to display the track memory window.

TRACK MEMORY

2000/8000 POINTS

Track memory window

4.Use the Cursor pad to select digit and use the ENTER knob to enter value.

5.Push the ENTER soft key or the ENTER knob. You are asked if you are sure to change the track memory capacity.

6.Push the ENTER knob.

7.Press the MENU key to close the menu.

3.6.6Erasing track

This paragraph shows you how to erase own ship’s track and target tracks. You can erase ship’s track three ways: collectively, by color and by area.

Erasing own ship track by area

You can erase own ship’s track by area as below. This feature is not available when the overlay mode is in use.

1.Press the MENU key followed by the CHART SETUP, TRACKS & MARKS CONTROL and ERASE T & M soft keys to show the ERASE menu.

ERASE ALL TRACKS

ERASE TRACKS BY AREA

ERASE TRACKS BY COLOR

ERASE TARGET TRACKS

ERASE ALL MARKS/LINES

ERASE MARKS BY AREA

SHIP’S TRACK STATUS

TRACKING

TRACK: 1234/2000

MARK : 9/6000

ERASE

EDIT

RETURN

Erase menu

2.Use the Cursor pad to select ERASE TRACKS BY AREA, then press the EDIT soft key. The menu is erased and the plotter display appears.

3.Use the Cursor pad to place the cursor at the top left-hand corner of the area which you want to ease track from.

4.Press the START soft key or the ENTER knob.

3-22