Furuno FS-5070 manual 10-4, Transmit message by one of the following methods, Send file screen

10. NBDP TRANSMITTING, RECEIVING

Note: If signal conditions are poor, connection may take a while. If the line could not be connected in one minute, calling stops and “Calling failed” appears. Try step 3 again, one minute later. Should signal conditions worsen during message transmission, “Error” appears in reverse video and 30 seconds later the line is disconnected.

5. Transmit message by one of the following methods:

Sending a file stored on a floppy disk

1.Press the function key F7 (WRU) to receive the answerback code of the other station. Verify that the code from the station called is correct.

2.Press the function key F8 (HR) to transmit your own identity (answerback code).

3.Press the function key F3 and then the 3 key to display the Send file screen.

4.Choose file to send and press the Enter key.

5.Press the Enter key again.

			Send File
[A:\TEST1.							]
	File name			Size	Date & Time
		52			02-10-15 17:25
LOG File
TEST1.		120			02-10-10 16:30
TEST2.		151			02-10-11 09:25
TEST3.		180			02-10-11 20:16
NBDP		169			02-10-12 06:23
[							]
		End of Directory
4 Files exist						1454000 bytes free
To select : ENTER To view : SPACE							To quit : ESC

Send file screen

Sending volume (percentage of message transmitted, counts upward as the message is being transmitted), ARQ error count and ARQ transmission time appear on the display. “Lock” appears in reverse video when the mark and space signals in the receive signal are normal. “ARQ Error” shows the number of times error was found during transmission. “ARQ Time” is the time in seconds the communication line has been established.

1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break

							2002-09-08 2:14:28 UTC		Caps-Eng
Station	Name	:						HT
Frequency (T/R)		:	8765.00	/ 8965.00(kHz)			Comm Mode :ARQ
Comm Status		:	Connect	Send	Lock	Error
Sending	Volume	:	100(%)	ARQ Error :		0	ARQ Time : 0(sec)

Communication status display

6.After the message is transmitted, press the function key F10 (Break) to disconnect the line.

Type a message from the keyboard

1.After exchanging answerback code by the function key F7 (WRU) and F8 (HR), type your message directly from the keyboard.

2.To change direction of traffic, press the function key F9 (OVER), or +, ? in order. Then, the other station becomes the information sending station, your station becomes the

10-4