2. INSTALLATION
2.6Initial Settings
Follow the procedures in this section to enter initial settings.
NOTICE
Improper menu settings may stop output of data and display the message "RATE ERROR." Be sure to enter correct data.
2.6.1Confirming satellite status; choosing mounting method
1. Turn on the processor unit and then press the [MENU] key to show the menu.
MAIN MENU
|
|
| SATELLITE |
ALARMS |
|
| |
MESSAGES |
|
| WAAS/DGPS |
GPS SETUP |
| I/O SETUP | |
SYS SETUP |
| INST MENU | |
SOFT VER. |
| ERASE | |
OTHERS |
| TRIP MENU | |
| |||
Main menu
2.Use the Omnipad (
) to choose “INST MENU” and then press the [ENT] key.
INSTALLATION SETUP 
MOUNTING : WALL
DIRECTION : A
LANGUAGE : ENG
ROLL OFFSET : 0.0
PITCH OFFSET : 0.0
Installation setup menu
3.Confirm that “MOUNTING” is selected and then press the [ENT] key.
4.Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or “INVERT” as appropriate.
5.Press the [ENT] key.
6.Choose “DIRECTION” and then press the [ENT] key.
7.Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as appropriate. Refer to section 2.3.1.
8.Press the [ENT] key.
9.Press the [SAT STATUS] key.
