GE 200D9366P020, 49-60612 installation instructions About the automatic icemaker

About the automatic icemaker. GEAppliances.com

A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Safety

Power		Automatic Icemaker (on some models)
Switch	Icemaker	The icemaker will produce seven cubes
		per cycle—approximately 100–130 cubes
		in a 24-hour period, depending on freezer
		compartment temperature, room
		temperature, number of door openings
		and other use conditions.
Green		See below for how to access ice and reach
	Feeler Arm	the power switch.
Power Light
		If the refrigerator is operated before the
		water connection is made to the icemaker,
		set the power switch in the O (off) position.
		When the refrigerator has been connected to
		the water supply, set the power switch to the
		l (on) position. The icemaker power light will
		turn green when the freezer light switch is
		pressed in or when the freezer door is closed.
		The icemaker will fill with water when it cools
		to 15°F (–10°C). A newly installed refrigerator
		may take 12 to 24 hours to begin making ice
		cubes.

You will hear a buzzing sound each time the icemaker fills with water.

Throw away the first few batches of ice to allow the water line to clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice.

NOTE: Set the power switch to the O (off) position if the water supply is shut off.

Instructions Operating Instructions

Shelf

Ice Bin

To reach the power switch.

Accessing Ice and Reaching

the Power Switch

Shelf

To reach the icemaker power switch, pull the shelf above the ice bin straight out. Always be sure to replace the shelf.

To access ice, simply pull the bin forward.

Ice Bin

To access ice.

Installation Instructions

Icemaker Accessory Kit

If your refrigerator did not come already	Check the back of the refrigerator for the
equipped with an automatic icemaker,	specific icemaker kit needed for your model.
an icemaker accessory kit is available at
extra cost.

Troubleshooting Tips

Dispenser Cradle

Spill Shelf

To Use the Dispenser

Press the glass gently against the top of the dispenser cradle.

The spill shelf is not self-draining. To reduce water spotting, the shelf should be cleaned regularly.

If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser arm and run 11⁄ gallons to remove trapped air from the

2

water line and to fill the water system. To flush out impurities in the water line, throw away the first six glassfuls of water.

Locking the Dispenser

Press the LOCK pad for 3 seconds to lock the dispenser and control panel. To unlock, press and hold the pad again for 3 seconds.

Door Alarm

To set the alarm, press the DOOR ALARM pad. The indicator light will illuminate. This alarm will sound if either door is open for more than 2 minutes. The beeping stops when you close the door.

11

Consumer Support