GE HSS25 manual Fresh Food Light, Water Filter Cartridge, Freezer Door Light Switch, Mounting Nuts

2.Disconnect the connectors for the door light switch and temperature control switches.

Connectors

Encoder

Board

GEA00870 Freezer Door Light Switch

3.Disconnect the connectors for the light and temperature control encoders.

4.Disconnect the temperature control encoder connector.

5.Remove the mounting nuts for both encoders.

Note: Both switches must be replaced because they are mounted on a common circuit board.

Mounting

Nuts

The freezer door light switch is located on the left of the freezer compartment.

1.Slide a small flat-blade screwdriver under the switch and push the locking tab. Pull out the switch.

2.Disconnect the harness connector and remove the switch.

GEA00871

6.Disconnect the refrigerator door light switch supply connector.

7.Push the locking tab in and slide the switch out of the panel.

Fresh Food Light

The lower fresh food light is located under an opaque cover in the lower portion of the fresh food compartment in some models.

Note: The upper light cover removal is covered in the previous procedure.

1.Remove the lower light cover by lifting it off the dowels.

2.Remove 2 40-watt appliance light bulbs.

Water Filter Cartridge

Note: The water filter should be replaced every 6 months. Warranty life is 30 days.

The water filter cartridge is located in the upper right corner of the fresh food compartment. When the LED illuminates, change the water filter. On those models without the LED, change the filter when the water flow decreases to the dispenser or icemaker.

1.Remove the old cartridge by slowly turning it to the left. Do not pull the cartridge down. A small amount of water may drip when the cartridge is removed.

– 19 –