Mounting Screws
Splash Baffle
GEA00879
3.Lift up the icemaker and slide it out until the cable connection is exposed.
Note: When replacing the icemaker, the fill cup and splash baffle must be reused.
4. Disconnect the cable connector.
Ice Dispenser Drive
The ice dispenser drive turns the ice dispenser auger in either crushed or cube mode.
1.Remove 2 Phillips screws from the ice dispenser drive.
2.Slide the dispenser out until the cable connector is visible.
3.Disconnect the cable and remove the dispenser drive.
2 Screws
Cable
Connector
GEA00880
5.Loosen 3 screws on the icemaker bracket.
6.Lift up the bracket and slide it out.
3 Screws
GEA00881
GEA00882
Evaporator Fan
The evaporator fan, located in the upper portion of the freezer compartment, circulates cold air through the fresh food and freezer compartments.
1.Remove auger motor housing.
2.Loosen 4 Phillips screws located in the lower portion of the evaporator fan duct.
3.Lift up the duct and slide it out.
– 22 –