4.Spread out the locking tabs and remove the switch.
5.Push the chute duct door locking tabs back and raise the assembly above the locking tabs.
6.Push the lower armature locking tabs (under the assembly) back and lift up the entire assembly.
Ice Crusher
The ice crusher uses a deflector. When the deflector is UP (“Crushed Ice” is selected on the dispenser control panel), the ice crusher operates. When the deflector panel is DOWN (“Cubed Ice” is selected on the dispenser control panel), the deflector is normally up.
1.Remove the ice dispenser tray and assembly (see page 21).
2.Remove 2 Phillips screws from the ice dispenser cover.
Screws
GEA00920
3.Turn over the ice bucket and ice dispenser cover. Remove the Phillips screw.
4.Remove the cover.
5.Remove the Phillips screw for the ice cube control linkage and slide the linkage to the rear of the ice bucket.
6.Using a pair of pliers, break the tabs off the back cover.
7.Using 2 flat blade screwdrivers, disengage the locking tabs at either side of the ice crusher and remove the assembly.
8.Slide the back cover off the auger. The back cover must be replaced because of tabs broken off for disassembly.
9.With a
10.Remove the auger and ice crusher blade assembly.
Ice Dispenser Drive Motor
The ice dispenser drive motor turns the auger in the crushed or cube mode.
1. Remove the ice dispenser tray and assembly.
– 25 –