Main Control Board
The main control board is located in the back of the unit. This board controls the operation of the unit.
1.Unplug the unit and remove the cover.
2.Disconnect all wiring harness connectors from the main control board.
3.Remove the board by unlocking the four plastic board standoffs located on the board.
Note: If standoffs are broken during disassembly, order new parts.
Main
Processor
Card
IMPORTANT: To ensure proper door closure, the refrigerator rollers must be adjusted to level the refrigerator. This is different from previous models.
Adjusting
Screw
Guide Pin
Roller
GEA00898
3.Turn the adjusting screw counterclockwise until it disengages from the assembly.
4.Remove the roller from the slot.
GEA00896
Water Solenoid
When the solenoids receive a signal from the processor, they route water to the water filter, cooler, and icemaker.
1. Remove the access cover.
2. Remove the solenoid bank bracket screw.
Roller Assembly
Adjustable roller assemblies are located at the bottom front of the unit. They are adjustable and replaceable.
1.Unsnap the base grille from the bottom of the unit.
2.Remove the guide pin with a
Bracket
Screw
GEA00899
3. Pull out and disconnect the cable connector.
– 28 –