Screws
GEA00894
5.With a file, score the capillary tube just above the soldered section. Break off the soldered section of the capillary tube. This helps prevent solder from plugging the tube during assembly.
6.Place a new evaporator into the freezer and insert the suction line and capillary tube into the evaporator.
7.Braze the suction line and capillary tube to the evaporator using silfos.
8.Install a replacement dryer.
9.Evacuate and recharge the system using currently accepted procedures.
Condenser Fan
The condenser fan provides
1.Remove the machine compartment access cover.
2.Remove 1 screw from the condenser fan mounting bracket.
Screw
GEA00895
3.Entire fan motor bracket and shroud assembly can be pulled out.
4.Remove 2 screws from the condenser fan cover.
5.Pull out the fan until the electrical connector is exposed.
6.Disconnect the electrical connector.
Electrical
Connector
GEA00725
Dispenser Heater
The dispenser heater ensures that the dispensing recess does not sweat in high humidity.
1.Remove 40 door liner mounting screws.
2.Remove the door liner.
Note: The door liner has
3.Remove the styrofoam dispenser cover.
4.Disconnect the wires and remove the heater.
Dispenser Heater
GEA00981
– 27 –