Installation

STEP 4 CONNECT RANGE TO GAS

WARNING

Do not use a flame to check for gas leaks.

Assure that gas supply is turned off at the shut-off valve:

•Apply pipe thread sealant to the gas inlet located at the back of the range. Install the 1/2" pipe elbow (provided) to the gas inlet.

•Connect 5/8" O.D. flexible metal connector

to gas inlet. Connect the other end of the flexible connector to the house gas supply.

•Turn on the gas and check for leaks:

–Use a liquid leak detector at all joints and connections in the system.

Gas

Inlet

IMPORTANT: Disconnect the range and the individual shut-off valve from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig. Isolate the range from the gas supply piping system by closing the individual manual shut-off valve to the range during any pressure testing of the gas supply piping system at test pressures equal to or less than

1/2 psig.

NOTE: This range is equipped with a gas shut-off valve located on top of the range, beneath the rear vent. This shut-off valve is to be used in the event that service is required in the future.

STEP 6 ROLL RANGE INTO POSITION

WARNING

The Anti-Tip Bracket must be properly installed to prevent tipping of the range. Failure to do so can cause serious damage or injury.

•Check to be sure the appliance runners are beneath the wheels.

•The range is shipped with the wheels in the down position. Carefully roll the range into position, being careful not to entangle or pinch the power cord and flexible gas tubing.

•Remove the runners beneath the range.

Be sure Anti-Tip Bracket is engaged with the brace

on the range.

STEP 5 CONNECT ELECTRICAL

•Plug power cord into properly grounded receptacle.

•Verify that power is connected by opening

the oven door or press the button on the left side of the control panel to illuminate the accent lighting.

14