Installation

STEP 9 CHECK BURNERS

Check to be sure that burner heads and caps are securely seated.

Burner Cap Properly Seated

Burner Cap Not Properly Seated

•Check for proper ignition:

–Push in one control knob and turn to LITE position.

–The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit.

–First test may require some time, while air is flushed out of the gas line.

–Turn knob to OFF.

–Repeat the procedure for each burner.

IMPORTANT: If the igniter electrodes continue to spark after the burners are lit, check that each burner component is assembled properly. Refer to the Owner’s Manual.

•Burner flames should be blue and stable with no yellow tips, excessive noise or lifting of the flame from the burner. If any of these conditions exist, check that the burner ports are not blocked.

If one of these conditions continues, call for service.

FINALIZE INSTALLATION

Place the burner grates over the burners.

The grates should be seated and should not rock.

The griddle is secured with screws. It is designed to be stationary and should not be removed.

The griddle has two leveling screws beneath the rear flue cover that can be used to adjust to the desired slope.

Griddle Flue Cover

Leveling Screws

Clamping Screws

The two inner screws are clamping screws for securing the griddle in place. Loosen these two screws before leveling. Do not remove these two screws.

The two outer screws are leveling screws. Do not remove these two screws. They can be turned to level the griddle or to provide a forward slope to help grease and oils drain away from the food being cooked.

After leveling the griddle, hand-tighten the clamping screws; do not over-tighten.

INSTALLATION CHECKLIST

❑Make sure all controls are left in the OFF position.

❑Make sure the flow of combustion and ventilation air to the range is unobstructed.

❑Recheck Steps:

Double check to make sure everything in this manual has been completed. Rechecking steps will ensure safe use of the range.

NOTE: The rating plateis located on the bottom

of the control panel and is visible when the oven door is opened. The model and serial number is behind the left knob and is visiblewhen the knob is pulled off.

16