Main
Orifice
Burner Orifices
Spark
Igniter

Installation Instructions

Convert Natural Gas to LP Gas Operation

Convert LP Gas to Natural Gas Operation

WARNING:This conversion must

be performed by a qualified installer or gas supplier in accordance with the manufacturer’s instructions and all codes and requirements of the authority having jurisdiction.Failureto follow instructions couldresult in seriousinjury or property damage. The qualified agencyperforming this work assumes responsibility for the conversion.

WARNING:The rangetop, as shipped from the factory, is set for use with its intended gas.If you wishto use yourrangetop with the alternate gas,you must first replace the orifices and convertthe pressure regulator.

WARNING:The following adjustments must be madebeforeturning on the burner.Failureto do so could result in serious injury. Be surepressure regulator has been converted as described in Step2.

TOOLS YOU NEEDED FOR CONVERSION

Crescent Wrench

1/4" and 7mm Nutdrivers

 

 

Small Flat-Head Screwdriver

Safety Glasses

(2 to 2.4 mm or 3/32" tip size,

60 mm long)

 

2 CONVERT THE REGULATOR

Disconnect all electrical power at the main circuit breaker or fuse box.

A. Remove the rear vent Range Regulator

trim (on ranges only) to access the regulator. The

Rangetop regulator is on the left bottom

corner.

B.Shut off the gas supplyby closing the manual shut-offvalve in the unit or at the wall.

C.Convert the pressureregulator:

•Unscrew the cap with plunger.

•Place your thumb against flat side of the plunger and press down to snap the plunger out of the cap.

•Carefully look at the plunger to locate the NAT or LP position.

• Turn the

Cap

Gasket

plunger

LP

 

over so

ATN

NAT

 

LP

that the

 

Plunger

desired gas

NAT

LP

is showing

LP

NAT

NAT. Position

LP Position

near the

 

 

bottom.

 

FOROFF

 

 

DOWN

Pressure Regulator

•Snap the plunger back intothe cap.

•Screw the cap back onto the regulator.

3 CHANGE BURNER ORIFICES

 

 

 

 

Philips

 

1/2" Deepwell

Small Pliers

Screwdriver

 

Socket Wrench

 

 

 

1

ORIFICE HOLDER

Griddle

Grill

Orifice

Orifice

The range orifice holder is located behindthe front access panel at the bottom of the range.

The rangetop orifice holder

is located insidethe range insulation cover.

Additional orificesmay be present. Use onlythe orifices specified in the instructions for your range or rangetop.

INSTALLATION TIP: First remove all orifices and then start replacing them. This will help to prevent the possibility that some may not be replaced.

Burner

A. Remove the burner grates, Head burner caps and burner heads.

B. Loosen the top burner orifices using a 7 mm nut driver.Use small

pliers to carefullyliftout the orifices.

The main orifice is located low in the center of the burner, while the simmer

orifice is located higher beside the center of the burner.

Burner Cap

Burner Base

Simmer

Orifice

21