Installation Instructions for Gas Conversion

5 CHANGE GRIDDLE ORIFICE (if present)

Locate the 3/4"long griddle orifice.

Selectforyour gas type.LP—.047,NAT—.076

A. Lift off the

griddle flue

Griddle Flue Cover

 

cover. Remove

 

A

 

 

the 2 inside

 

 

clamping

 

 

 

screws.

 

 

 

B. Lift out the

 

 

 

cast-iron

 

 

NOTE: Remove

grease trough.

Leveling Screws

the 2 screws

Slide the

positioned on

griddle toward

 

 

the inside only.

 

 

Do not remove

the rearand

Clamping Screws

the outermost

out of the

screws—they

hold-down

 

 

are for leveling.

tabs along the

 

B

 

bottom.

 

 

C. Carefully lift and hold

 

 

the griddle while pulling

 

 

additionallength of the

 

 

capillary from the entry

 

 

hole. Stand the griddleon

 

 

end in the grease sump.

 

 

D. Remove the 2 hold-down

C

 

screws at the rear of the

 

 

burner.

 

 

Capillary

 

 

 

Pull the burnerstraight back toward the rearand out of the gas inlet.

E.Use a 1/2” deepwell socket to remove and replace the orifice.

D

Back of Range

E

Front of Range

Reverse these steps to reassemblethe griddle. Push excess capillary back into the entryhole. Place the unused orificein the holderfor possible future use.

6 ADJUST BURNER FLAMES

Normally, burners donotneedfurther adjustment. Makeadjustmentsonly when necessary.

A.Turn on the gas. Plug in electrical cord.

B.Turn all burners on highest setting and check the flames. They should be blue in color.When using LPgas, the flames may have some yellow tipping at the ends of the flame. Foreign particles in the gas line may cause an orange flame at first, but this will soon disappear.

C.Turn the burner knob to “LO” while observing the flame.

Adjust the setting of the upper row of flames using the valve bypass screw as follows:

Adjustments must be made with two other burners in operation on a medium setting. This prevents the upper row of flames from being set too low, resulting in the flame being extinguished when other burners are turned on.

D. Toadjust the flame, removethe knobs. Inserta small flat-blade screwdriver into the hole in the center

of the valvestem to engagescrew.

•If the flames are too small or flutter, turn the screw counterclockwise.

•If the flames are too large, turn the screw clockwise.

E.Make the adjustment by slowly turning the screw until flame appearance is correct.

Once the conversion is completeand checked, fillout the conversionlabel and affixthe label near the rating label. For ranges, place the labelbeneaththe controlpanel. For rangetops,placethe label on the bottom of the unit.

23