ZX12B30PSS, ZX12B36PSS,ZX12B48PSS AccessoryInstallation

OPTIONAL ACCESSORIES—12" HIGH BACKSPLASH

WARNING:

To prevent ignition of combustible materials, the entire back wall above the range must be protected by a backsplash constructed of non-combustible material.

This stainless steel backsplash accessory

must be installed in combination with a custom, non-combustible backsplash built beyond

the 12" height of the backsplash.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT: Save these instructions for local inspector’s use.IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.

NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference.

This kit provides for the installation of a 12" high backsplash for 30", 36" or 48" Monogram Professional Ranges and Rangetops.

TOOLS AND MATERIALS REQUIRED

• Gloves to protect against sharp edges

•

T-15 and #2 Phillips screwdrivers

Wall Support

•

Drill with 3/32" and 9/64" bits

Panel

•

Safety glasses

 

 

•

Level

Cover Panel

 

•

Pencil

 

 

 

This Kit Includes

•Wall support panel

•Cover panel

• Hardware package with

– 5

Stainless Steel Torx 15 #8

 

self-tapping screws

Hardware

– 5

Phillips #2 pan head wood

Package

#10 screws

INSTALL 12" BACKSPLASH

WARNING: This backsplash must be securely fastened to the wall. Failure to do so could result in damage or personal injury.

•Install and level the range or rangetop and the range hood according to the installation instructions.

•Remove the backsplash packaging and protectivefilm.

•Use a level to pencil a horizontal line on the wall, 1/8" above the range or rangetop. The 1/8" gap allows the cover panel to overlap the wall support panel.

•Locatewall studs on each side. Where studs are not available, plan to use wall anchors (not provided).

•Align the wall support panel on the marked horizontal line and centered left to right.

•The wall support panel must be secured to the wall at all 4 corners. Use wood screws (provided)or wall anchors (not provided) to secure the support panel to the wall.

•Place the cover panel over the wall support panel and secure with Torx screws (provided). Install 2 screws on each side.

 

Install 4 Wood

 

Screws

 

Wall Support

 

Panel

 

Center

1/8″

Arrow

 

Install T-15

Wall

Screws

Cover Panel

Support

 

Panel

 

18