Installation

STEP 7 LEVEL THE RANGE

WARNING

The range must be level and be supported

by the legs—not the wheels. The range could move if the wheels make contact with the floor. Be sure all legs make contact with the floor in any installation.

•All legs must be leveled after the product is installed.

•Check to be sure the adjoining cabinets/ countertops are level, front to back and left to right across the opening of the range.

•Measure the distance from the floor to the top

of the countertop in the left and right rear corners.

•Adjust the height of the range to countertop height or higher.

IMPORTANT: This range should always be installed at countertop height or higher. DO NOT INSTALL THE RANGE LOWER THAN ADJACENT COUNTERTOP HEIGHT. The range must be supported by all 4 legs, regardless of countertop height.

FRONT LEG ADJUSTMENT

•Slide front cylinders up to adjust front leveling legs. Be careful not to damage cylinder.

•A leveling leg wrench is supplied. Reach under the front of the range near the right side. Locate and remove a thumb screw, then slide wrench out of the slot.

Thumb Screw

Slide leg cylinder up.

•Use the supplied wrench to turn the front leveling legs. Turn clockwise to raise the range above the wheels. Turn counterclockwise to lower the legs.

•Be sure to return the wrench to its storage slot for future use.

15

STEP 7 LEVEL THE RANGE (cont.)REAR LEG ADJUSTMENT

•Remove two screws from rear vent trim. Slide vent trim forward, then lift up to remove.

•Find the two rear leg extension rods. Use a 1/4" driver or wrench to adjust the left or right rear legs.

Rear Vent Trim

Rear Leg

Extension Rod

•Replace the rear vent trim using the original screws.

STEP 8 REPLACE OVEN DOOR(S)Skip this step if oven doors are in place.

IMPORTANT: Do not lift the door by the handle.

To replace the oven doors:

•Firmly grasp the door at the top sides.

This is critical.

•Approach the range with the door angled in a vertical position.

•Guide the hinges into the slots. •Push the door in firmly while opening.

•Once in position, open the door completely. Push the hinge locks back in and toward the front frame.

CAUTION: Take care when replacing the oven doors. If the hinge latch is not securely locked, the hinge may snap back and separate.

If the hinge separates, you must apply pressure (possibly with your foot) to press it back together and then engage the hinge latch.