Install Rear Mounting Screws

Installation Instructions

UNDER-CABINET INSTALLATION

8 CONNECT ELECTRICAL

WARNING: If house wiring is not 2-wire with a ground wire, a ground must be provided by the installer. When house wiring is aluminum, be sure to use U.L. approved anti-oxidant compound and aluminum-to-copper connectors.

ADVERTISSEMENT :

Si la maison n’est pas câblee avec deux fils et un fil de terre, l’installateur doit installer un fil de terre. Quand les fils sont en aluminium, il faut prendre soin d’utiliser des connecteurs aluminium à cuivre avec une pâte antioxydante approuvée par U.L.

•Remove junction box cover and knockout.

•Use a conduit connector to secure the conduit to the junction box.

•Connect white leads to branch circuit white lead.

•Connect black leads to branch circuit black lead.

•Connect green/yellow leads to branch circuit green lead or bare ground lead.

•Secure all connections with wire nuts on each electrical connector.

•Push wires into junction box and replace cover. Be sure wires are not pinched.

•Secure electrical panel cover with screws provided.

10INSTALL FILTERS

•Remove protective film on the filters.

Filter Locks

NOTE: It is not necessary to install the charcoal filter in a vented installation.

•Tip the filter into the slots at the rear of the opening. Lift the filter lock and pull forward until the filter rests in the slots.

•Install both metal grease filters.

•To remove the filters, press inwards on the handle and pull the filter downwards.

9INSTALL REAR MOUNTING SCREWS

Install 2 Wood Screws

•Pull the glass canopy forward to access and install 2 wood screws or fasteners through the bottom of the hood and into the wall.

GE ZV800 Install Rear Mounting Screws, Remove protective film on the filters

Models: ZV800