Installation Instructions
WALL-MOUNTED INSTALLATION—RECIRCULATING
2 INSTALL MOUNTING BRACKET
This vent hood must be secured to the horizontal support or wall studs.
•With the template taped in place, use a punch to mark all mounting screw locations.
•Drill 1/8” pilot holes at the 6 punched locations.
•Remove the template.
•The 2 holes in the support bracket holes must enter studs or the horizontal support.
•Use wood screws to secure the mounting bracket to the wall. The screws must engage wall studs or the installed horizontal mounting support.
•Check to be sure that the bracket is level. There is no way to level the hood after hanging it from this bracket.
3PREPARE THE HOOD
•Remove the hood from the box. Remove packaging and tape.
Electrical | Remove 2 side |
panel | cover screws |
•Remove one screw on each side of the cover on the electrical panel. Lift off the cover and set aside with screws.
Junction box |
Inside screw |
Secure |
electrical panel |
with 3 screws |
•Stand the electrical panel upright.
•Align the screw holes in the bottom of the panel with the holes on the base of the hood at the front side.
•Install 3 screws provided.
• Snap the damper into the |
| Install |
|
exhaust outlet on the top of |
|
| |
the hood. |
| damper |
|
|
|
|
|
15
