Generac Power Systems 941-2 Part, Nominal Resistances Of Generator Windings, Load %, Voltage Vac

		Part 8
		SPECIFICATIONS & CHARTS
TYPE	Impact 36 G	Impact 36 LP
MODEL	0940	0941
TYPE OF ROTOR	Permanent Magnet Type	Permanent Magnet Type
RATED WATTS	3600	3400
RATED VOLTS	115	115
PHASE	1-Phase	1-Phase
RATED MAXIMUM	30.0	28.3
LOAD AMPERES
RATED FREQUENCY	60 Hz	60 Hz
OPERATING SPEED	Variable	Variable
(See NOTE 1)
ENGINE MODEL	GV-220	GV-220
TYPE OF ENGINE	Vertical Shaft	Vertical Shaft
FUEL SYSTEM	Gasoline	LP Gas
COOLING SYSTEM	Air-Cooled	Air-Cooled
OIL SYSTEM	Pressure	Pressure
OIL PUMP	Trochoid Type	Trochoid Type
AIR CLEANER	Paper element	Paper element
	w/foam pre-cleaner	w/foam pre-cleaner
STARTER	12 VDC electric	12 VDC electric
IGNITION SYSTEM	Solid State	Solid State
SPARK PLUG	Champion RC12YC	Champion RC12YC
	(or equivalent)	(or equivalent)
SPARK PLUG GAP	0.030 inch	0.030 inch
	(0.76mm)	(0.76mm)

NOTE 1: Engine speed will vary between approximately 2400-4000 rpm, depending on the load and load voltage.

NOMINAL RESISTANCES OF GENERATOR WINDINGS

Stator Power Phase Windings
Lead AC1	0.414 to 0.465 ohm
Lead AC2	0.414 to 0.465 ohm
Lead SL1	0.414 to 0.465 ohm
Lead SL2	0.414 to 0.465 ohm
Stator Power Phase Winding
Lead PS1	0.206 to 0.227 ohm

Stator Timing Winding
Lead TIM1 (orange)
to TIM2 (grey)	0.102 to 0.116 ohm
Stator Battery Charge Windings
Lead 55 to 77	0.095 to 0.108 ohm
Lead 55 to 66	0.095 to 0.108 ohm

ENGINE SPEEDS AND VOLTAGE SPECIFICATIONS

Listed below are normal running voltages, load voltages, engine speeds and frequency ranges.

LOAD %	VOLTAGE (VAC)	FREQUENCY (Hz)	ENGINE SPEED (rpm)
0	121-112	61-59	2800-2400
50	120-109	61-59	3500-3000
100	120-109	61-59	4000-3500

Page 8-1