Automatic Gap Adjust

This, the easiest method, causes the printer to automatically make the adjustment based upon the form thickness selected. This is the recommended method. An "offset" to this automatic adjustment may be selected in order to fine-tune the gap to your forms. The range of the offset is from -3/+5. With or without an offset, the printer will automatically make the adjustment each time you load a new set of forms. Please note that for forms of varying thickness, this method may or may not make an appropriate adjustment depending upon which area of the form was used during the adjust procedure.

The automatic gap value will be stored as a "path" parameter or as a "format" parameter based upon the GAP ASSIGN selection in the System Menu.

If GAP ASSIGN:PATH is selected in the System Menu, then the offset value will be stored for the currently selected path and will be recalled the next time paper is loaded in the current path.

If GAP ASSIGN:FORMAT is selected in the System Menu then the offset value will be stored in the current format. The current format must be saved to a numbered (1-4) format. Then, the next time that particular format number is selected, the offset gap value will be recalled.

FORM: AUTO

ENTER

FORM:AUTO>0

↓ or ↑

98