The Initial Set-Up (ISU) Menu

There are three primary headings in the Initial Set Up Menu as shown below. Each primary heading has one or two levels below it:

1.INITIALIZE

2.ALIGNMENT

3.SENSOR TUNE

Entering Initial Set-Up Menu

To enter the Initial Set-Up Menu, proceed as follows:

1.Turn off the printer's power.

2.Press and hold the LINE FEED and FF/LOAD keys.

3.While holding these keys, turn on the printer's power. Shortly, after the power comes up, the LCD displays the following message:

INITIAL MENU

4.Release the LINE FEED and FF/LOAD keys. The LCD displays the first menu item:

INITIALIZE

Moving within the Initial Set-Up Menu

1.Press the ENTER key to go into the next Front1 level of the menu.

2.Use the ↑ or the ↓ keys to scroll within a level as well as to change parameter value display at the selection level.

3.Press the ENTER key to save selections at the selection level (SAVING CHANGE displays). The selection level is apparent whenever the LCD is flashing on and off.

4.Use the PRIOR key to go to the next higher level as well as to not save a selection at the selection level.

32