FIG. 18

6.If the operator wants to top-off fluids, press the left arrow key to display the TOP-OFF MODE. See FIG. 19.

FIG. 19

7.Pull the trigger to dispense the desired fluid amount for top-off.

8.Press END to complete the job. See FIG. 19. This logs the dispense to the PC and returns the meter to its programmed entry screen.

If END is not pressed, after 5 minutes the meter will time out and log the dispense to the PC.

Restricted Preset Dispense Mode

When meters are programmed in restricted preset mode, the specified dispense value cannot be increased, only decreased. The functionality of this fea- ture is identical to Preset Dispense Mode (see Preset Dispense Mode beginning on page 14) except that the preset value can only decreased with the down keypad button.

Meter Operation

Removing and Replacing the Battery

1.Remove the battery by pressing in on both battery lock buttons (E) and pulling the battery (F) out and away from the meter. See FIG. 20.

2.Place the battery in the battery charger. See Instruction Manual 309502 for details.

3.Replace the battery by pressing in on both battery lock buttons (E) and pushing the battery (F) into the meter.

If the meter displays a low battery warning, wait 30 seconds before installing a new battery. See Bat- tery Life Indicator page 10.

.

E

F ti64318

FIG. 20

Quick-LockNozzle

The nozzle opens and closes with LESS THAN one turn.

1.To close the nozzle to prevent dripping, rotate left (counter clockwise) until tight. See FIG. 21.

2.To open the nozzle for dispensing, rotate right (clockwise) until fully open.

Open

Close

ti64319

FIG. 21

309497L

15

Page 15
Image 15
Graco 246008, 249881 Restricted Preset Dispense Mode, Removing and Replacing the Battery, Quick-LockNozzle