TABLE 12: ADVANCED SETTINGS CONFIGURATION PAGE DEFINITIONS
|
|
|
|
|
|
|
|
| Admin Password |
| Administrator password. Only the administrator can configure the “Advanced Settings” page and |
| |||
|
|
| |||||
|
|
| “Account x” pages. Password field is purposely blank for security reasons after clicking update and |
| |||
|
|
| saved. The maximum password length is 25 characters. |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| G723 rate |
|
|
| |||
|
| G.723 audio codec encoding rate, either 6.3kbps or 5.3kbps, check with ITSP or Server/Proxy. |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Silence |
|
|
| |||
|
| This controls the silence suppression/VAD feature of the audio codec G.723 and G.729. |
| ||||
| Suppression |
| If set to “Yes”, when silence is detected, a small quantity of VAD packets (instead of audio pack- |
| |||
|
|
| ets) will be sent during the period of no talking. |
|
|
| |
|
|
| If set to “No”, this feature is disabled. |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Voice Frames |
|
|
| |||
|
| This field contains the number of voice frames to be transmitted in a single Ethernet packet (be |
| ||||
| per TX |
| advised the limit is based on the maximum size of Ethernet packet which is 1500 byte or 12kbps). |
| |||
|
|
| When setting this value, be aware the requested packet time (ptime, used in SDP message) is a |
| |||
|
|
| result of configuring this parameter. This parameter is associated with the first codec in the above |
| |||
|
|
| codec Preference List or the actual used payload type negotiated between the 2 conversation par- |
| |||
|
|
| ties at run time. e.g., if the first codec is configured as G.723 and the “Voice Frames per TX” is set |
| |||
|
|
| to 2, then the “ptime” value in the SDP message of an INVITE request will be 60ms because each |
| |||
|
|
| G.723 voice frame contains 30ms of audio. Similarly, if this field is set to 2 and the first codec is |
| |||
|
|
| G.729 or G.711 or G.726, then the “ptime” value in the SDP message of an INVITE request will be |
| |||
|
|
| 20ms. |
|
|
|
|
|
|
| If the configured voice frames per TX exceeds the maximum allowed value, the IP phone will use |
| |||
|
|
| and save the maximum allowed value for the corresponding first codec choice. The maximum val- |
| |||
|
|
| ue for PCM is 10 (x10ms) frames; for G.726, it is 20 (x10ms) frames; for G.723, it is 32 (x30ms) |
| |||
|
|
| frames; for G.729/G.728, 64 (x10ms) and 64 (x2.5ms) frames respectively. |
|
|
| |
|
|
| Please be careful when editing these parameters. Adjusting these parameters will also change the |
| |||
|
|
| jitter buffer. The GXV300x has a patent jitter buffer handling algorithm. |
|
|
| |
|
|
| Grandstream recommends using the default settings and not adjusting these parameters. |
| |||
|
|
| Incorrect settings will affect the voice quality. |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Video Frame Rate |
|
|
| |||
|
| Default value is 15 frames/second. The video frame rate is adjustable based on network condi- |
| ||||
|
|
| tions. Increasing the frame rate will increase the amount of data significantly therefore con- |
| |||
|
|
| suming more bandwidth. Lack of bandwidth the video will get impaired due to packet loss. |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Video bit rate |
|
|
| |||
|
| Default value is 128 kbps. The video bit rate is adjustable based on network environment. |
| ||||
| (kbps) |
| Increasing video bit rate may improve video quality if bandwidth allows. |
|
|
| |
|
|
| Otherwise the video quality will get impaired due to packet loss. |
|
|
| |
|
|
| Video downloading bit rate can also be adjusted after video conversation is established. |
| |||
|
|
| - Use MWI button | to toggle between VOLUME, BIT RATE, and Tone Remapping Filter |
| ||
|
|
| mode. |
|
|
|
|
|
|
| - After choosing the feature, use UP and DOWN arrow button to adjust. By pressing the UP and |
| |||
|
|
| DOWN button, GXV300X sends out SIP INFO to tell remote party increase/decrease its uploading |
| |||
|
|
| rate. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Video Packet Size |
| Default value is 1400, range from 100 to 1400. |
|
|
| |
|
|
|
|
| |||
|
|
| Recommended using 600~800 if you have Outbound Proxy or Media Gateway. |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Video Rate |
| Frame or TMN8. Default is Frame. |
|
|
| |
|
|
|
|
| |||
| Control |
| TMN8 is good for bandwidth bigger than 384kbps |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Grandstream Networks, Inc. | GXV300x User Manual | Page 27 of 54 |
| |||
|
|
|
| Firmware 1.2.3.7 | Updated: 12/2010 |
| |
