Fence Components
Components and Hardware Needed: | Qty |
Fence Knob | 1 |
Fence Resting Brackets | 2 |
Flange Bolts | 2 |
To install the fence knobs, fence, and fence resting brackets:
1.Install the fence knob as shown in Figure 32.
Figure 32. Fence knob installed.
2.Install the fence onto the table to the right of the blade.
3.Check for fence parallelism and adjust if needed. See Adjusting Fence on Page 54.
4.Install the fence resting brackets (Figure 33) onto the back of the cabinet with the two flange bolts.
Brackets
Figure 33. Fence resting brackets installed.
Dust Collection
DO NOT operate the Model G0605X/G0606X without an adequate dust collection system. This saw creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Components and Hardware Needed: | Qty |
4" Dust Hose (not included) | 1 |
4" Hose Clamp (not included) | 2 |
Dust Collection System (not included) | 1 |
Recommended CFM at Dust Port: 400 CFM Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or wyes, and the amount of other open lines throughout the system. Explaining this cal- culation is beyond the scope of this manual. If you are unsure of your system, consult an expert or purchase a good dust collection
To connect a dust collection hose:
1.Fit the 4" dust hose over the dust port, as shown in Figure 34, and secure in place with a hose clamp.
2.Tug the hose to make sure it does not come off. Note: A tight fit is necessary for proper performance.
