4.Loosen the jam nut (Figure 73) on the 45° stop bolt, adjust the stop bolt up or down, then check to see if the blade is 45° to the table.
45° Stop Bolt
Jam Nut
Figure 73. 45° stop bolt and jam nut.
5.Continue adjusting the stop bolt until it con- tacts the cabinet when the blade is at 45°.
6.Tighten the jam nut.
To adjust the tilt indicator arrow:
1.Set the 90° stop bolt (see instructions on Page 50).
2.Loosen the blade height handwheel set screw and remove the handwheel.
3.Loosen the button head cap screw shown in Figure 74 and move the tip of the indicator to 0°.
Indicator
Button Head
Cap Screw
| Figure 74. Tilt indicator arrow. |
4. | Tighten the cap screw and reinstall the |
| handwheel. |
G0605X/G0606X Extreme Series 12" Table Saw
Digital Readout
The digital readout displays the current blade angle. We recommend you set the readout after verifying the 90° and 45° blade tilt stops.
To set the digital readout:
1.Ensure the 90° stop bolt is set (see Blade Tilt Stops on Page 50.
2.Move the blade angle to 0° and press the 0° SET button (Figure 75) for several seconds until the readout displays 0.00.
0° Set Button | 45° Set Button |
Figure 75. Digital readout.
3.Move the blade angle to 45° and press the SET button for several seconds until the readout displays 45.0.
Note: If you move the blade angle handwheel when the power is disconnected, the digital readout will be incorrect when the saw is reconnected.
