Grizzly G0605X/G0606X owner manual Service, Troubleshooting, Motor & Electrical

SECTION 7: SERVICE

Review the troubleshooting and procedures in this section to fix your machine if a problem develops. If you need replacement parts or you are unsure of your repair skills, then feel free to call our Technical Support at (570) 546-9663.

Troubleshooting

Motor & Electrical

Symptom		Possible Cause		Possible Solution
Machine	does not	1.	Plug/receptacle is at fault or wired incor-	1.	Test for good contacts; correct the wiring.
start or	a breaker		rectly.
trips.		2.	Start capacitor is at fault (G0605X only).	2.	Test/replace if faulty.
		3.	Motor connection wired incorrectly.	3.	Correct motor wiring connections.
		4.	Thermal overload relay has tripped.	4.	Unplug machine, open magnetic switch cover, turn
					amperage dial on Thermal Protection Circuit Breaker
					to a higher amperage setting.
		5.	Contactor not getting energized/has burnt	5.	Test for power on all legs and contactor operation.
			contacts.		Replace unit if faulty.
		6.	Wall fuse/circuit breaker is blown/tripped.	6.	Ensure correct size for machine load (refer to Page
					12); replace weak breaker.
		7.	Power supply is at fault/switched OFF.	7.	Ensure hot lines have correct voltage on all legs and
					main power supply is switched ON.
		8.	Motor ON button or ON/OFF switch is at	8.	Replace faulty ON button or ON/OFF switch.
			fault.
		9.	Centrifugal Switch is at fault (G0605X	9.	Adjust/replace the centrifugal switch if available.
			only).
		10. Wiring is open/has high resistance.		10. Check for broken wires or disconnected/corroded
					connections, and repair/replace as necessary.
		11. Motor is at fault.		11. Test/repair/replace.
		12. Start delay module is at fault.		12. Adjust to correct delay; replace module.
Machine stalls or is		1.	Applying too much pressure to workpiece.	1.	Use sharp blade, and reduce the feed rate.
underpowered.		2.	Run capacitor is at fault (G0605X only).	2.	Test/repair/replace.
		3.	Belt slipping.	3.	Replace bad belt, align pulleys, and re-tension.
		4.	Motor connection is wired incorrectly.	4.	Correct motor wiring connections.
		5.	Plug/receptacle is at fault.	5.	Test for good contacts; correct the wiring.
		6.	Motor bearings are at fault.	6.	Test by rotating shaft; rotational grinding/loose shaft
					requires bearing replacement.
		7.	Motor has overheated.	7.	Clean off motor, let cool, and reduce workload.
		8.	Contactor not getting energized or has poor	8.	Test for power on all legs and contactor operation.
			contacts.		Replace if faulty.
		9.	Motor is at fault.	9.	Test/repair/replace.
		10. Centrifugal switch is at fault (G0605X).		10. Adjust/replace centrifugal switch if available.
		11. Start delay module at fault (G0606X only).		11. Adjust to correct delay; replace module.

-46- G0605X/G0606X Extreme Series 12" Table Saw