Grizzly G0605X/G0606X owner manual Extension Table, Components and Hardware Needed Qty

Extension Table
Components and Hardware Needed:	Qty
Table Saw Unit	1
Front Rail	1
Rear Rail	1
Front (Main) Extension Table	1
Lower Shelf	1
Shelf End Plate	1
Support Legs	2
Lower Shelf Brackets	2
Cap Screws M8-1.25 x 25	8
Flat Head Screws M8-1.25 x 25	8
Flat Washers 8mm	16
Hex Nuts M8-1.25	8
Flange Bolts M8-1.25 x 12	9
Lock Washers 8mm	8
Hex Bolts M6-1 x 12	4
Hex Bolts M10-1.5 x 25	2
Feet 3⁄8-16 x 2	2
Phillip Head Screws M6-1 x 12	12
Hex Nuts M6-1	2
Hex Nuts 3⁄8-16	2
Flat Washers 6mm	16
Flat Washers 10mm	2
To install the front and rear rails:

1.Fasten the 913/8" front rail onto the table saw with five flat head screws as shown in Figure 10.

Figure 10. Front rail installed.

G0605X/G0606X Extreme Series 12" Table Saw

2.Fasten the 79" rear rail to the table with five cap screws and lock washers as shown in Figure 11.

Figure 11. Rear rail installed.

3.Thread two M10-1.5 x 25 hex bolts with flat washers onto the right side of the table saw cabinet as shown in Figure 12. Do not fully tighten the bolts.

Hex Bolts

Figure 12. Hex bolts installed.

4.With the help of an assistant, place the exten- sion table between the rails and slide the table slots over the bolts installed in Step 3.

-19-