10.Lower the arbor down all the way, remove the button head cap screws on the lower part of the belt cover plate, the spacers, and the cover plate.
11.Roll the belt off of the upper and lower pul- leys. Be careful not to pinch your fingers.
To install the new belt:
1.Place the new flat belt onto the lower pulley so it engages one or two grooves.
2.Push the belt inward and roll it onto the top pulley. Continue pushing the belt and rotating it up and down (FIgure 68) until it is centered on both pulleys.
Flat Belt
Figure 68. Installing flat belt (table removed for
clarity.)
3.Reinstall two button head cap screws and spacers onto the lower part of the belt cover plate.
4.Raise the blade all the way up.
5.Perform Steps 6-9 in the previous subsection in reverse order.
6.Loosen the motor mounting hex nuts, place the wood block on top of the motor.
7.Raise the arbor assembly to tension the belt, ensuring that the wood block is between the motor and cabinet, as shown in Figure 69.
Wood
Block
Figure 69. Using wood block to tension belt.
8.Check belt deflection, as shown in Figure 70.
Note: The belt is tensioned correctly when you can deflect it no more than 1/8".
������
����������
������
Figure 70. Checking belt deflection.
9.Tighten the motor mounitng hex nuts, lower the motor, and remove the wood block.
10.Close the motor cover.
G0605X/G0606X Extreme Series 12" Table Saw |
