GTO SL-1000B, SL-2000B installation manual Preparing the Gates, Control Unit

PREPARING THE GATES

Install PVC conduit (not included) needed for power cables and low voltage wiring – see illustration below. The PRO SL-1200 and SL-2200 power cable and safety edge (required) wiring should be run through PVC conduit underneath the driveway. If you cut the driveway be sure to reseal it after all wiring is installed.

			Contact Sensor
		Roller Guard	(REQUIRED)
Contact Sensor	Contact Sensor	(REQUIRED)	Receiver
(REQUIRED)	(REQUIRED)		(cable in separate
			conduit)

!WARNING

	Injury Or Death		120 Volt Indoor
	Moving Gate Can Cause
		Chain Bracket	Transformer
	Chain Bracket
		STAND CLEAR	(Surge Protector
		CAUTION	not supplied)
		SL-1000
		or SL-2000
		First Operator
	Chain		Roller Guard
			(REQUIRED)
	Roller Guard
PVC Conduit for	(REQUIRED)
	First Gate Operator		Run up to 1000' of low
power cable.		PVC Conduit for
			voltage wire to control
second operator
	(Control Unit)	power cable.	box from transformer
			(wire not included).

Contact Sensor	Roller Guard		Contact Sensor
	(REQUIRED)
(REQUIRED)		Contact Sensor	(REQUIRED)
		(REQUIRED)
		! WARNING
		Moving Gate Can Cause
		Injury Or Death
	Chain Bracket
	CAUTION		Chain Bracket
	STAND CLEAR
	SL-1200
	or SL-2200
	Second Operator
			Chain
Roller Guard		Roller Guard	PVC Conduit for
(REQUIRED)		(REQUIRED)
			second operator
Second Gate Operator			power cable.
(Auxiliary Unit)

34