SINGLE GATE OPERATOR INSTALLATION
GATE PREPARATION
Be sure the gate is properly installed and slides smoothly before installing the GTO/PRO Slide Gate Operator. The gate must be plumb, level, and move freely. The gate must not bind or drag on the ground. Never use a wheel on the gate, because the additional drag and resistance can cause the operator to obstruct.
Level |
Plumb |
Concrete |
Concrete |
OVERVIEW OF OPERATOR INSTALLATION
The diagram below shows a single slide gate installation with recommended safety features. The operator must be installed on the inside of the gate. GTO requires using safety edges and roller guards to help reduce the possibility of bodily injury.
|
|
| Contact Sensor |
|
| Roller Guard | (REQUIRED) |
|
|
| |
Contact Sensor | Contact Sensor | (REQUIRED) | Receiver |
| |||
(REQUIRED) | (REQUIRED) |
| (cable in separate |
|
|
| conduit) |
!WARNING
Moving Gate Can Cause | 120 Volt Indoor |
Injury Or Death | Transformer |
Chain Bracket | Chain Bracket |
|
STAND CLEAR | (Surge Protector | |
|
| |
| CAUTION | not supplied) |
| Operator |
|
Chain | Roller Guard |
| (REQUIRED) |
Roller Guard |
|
(REQUIRED) |
|
Use PVC Conduit | Run 1000' (max.) of low |
voltage wire to control | |
(not included) | box from transformer |
for power cables. | (wire not included). |
12
