Domestic Air Conditioner | |
Model: |
3 Installation of the Indoor Unit
Drawing of pipe
Rear piping
Draw pipes and the drain hose, then fasten them with the adhesive tape
Left 
Left-rear piping 
In case of left side piping, cut away, with a nipper, the lid for left piping.
In case of
Insert the drain hose into the dent of heat insulation materials of indoor unit.
Insert the indoor/outdoor electric cable from backside of indoor unit, and pull it out on the front side, then connect them.
Coat the flaring seal face with refrigerant oil and connect pipes.
Cover the connection part with heat insulation materials closely, and make sure fixing with adhesive tape.
Lid for right piping
Heat insulation | Piping |
material |
|
| Pipe supporting |
| plate |
Drain hose | Indoor/Outdoor |
| Electric cable |
Lid for left piping
Lid for under piping pipe
Fix with adhesive tape
Indoor/outdoor electric cable and drain hose must be bound with refrigerant piping by protecting tape.
Other direction piping 
Cut away, with a nipper, the lid for piping according to the piping direction and then bend the pipe according to the position of wall hole. When bending, be careful not to crash pipes.
Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat insulation of connecting part specially.
Fixing the indoor unit body
Hang surely the unit body onto the upper notches of the mounting plate. Move the body from side to side to verify its secure fixing.
In order to fix the body onto the mounting plate, hold up the body aslant from the underside and then put it down perpendicularly.
4 Connecting the indoor/outdoor Electric Cable
Removing the wiring cover
Remove terminal cover at right bottom corner of indoor unit, then take off wiring cover by removing its screws.
60
