1314
1516
1718
B
A
1920
13.Rest the magazine retention groove on the magazine sup- port on the camera body ensuring that they are correctly positioned.
14.Swing the magazine towards the camera body and
firmly press into place with a click. If there is resistance, the magazine retaining hook has probably been inadvertently released. Push the magazine retaining latch to the right and inwards simultaneously again to reset it.
15.Remove the top protective cover from the viewfinder screen location by lifting a corner.
16.Remove the protective cover from the viewfinder by depress- ing the viewfinder release button.
17.While holding the viewfinder at a slight angle, locate the front section into place on the front edge of the viewfinder screen recess in the camera body ensuring the central locat- ing lug and databus interface are positioned correctly. Swing the viewfinder downwards and press firmly until it clicks into place. Ensure that both sides of the viewfinder are seated correctly.
18.Point the camera at a smooth toned area. Turn the eyesight adjustment dial until you achieve optimum sharpness of the markings on the viewfinder screen.
..........................................................................
The camera is now complete. If you press the ON.OFF button A for half a second, the camera will activate. If the camera enters STANDBY mode (the LCD screen will show the H2 symbol only), reactivate it by press- ing the shutter release button B halfway (or the ON.OFF button).
You can now explore the menus, buttons, control wheels, etc observing the changes on the LCD on the grip as well as the LCD in the viewfinder.
film loading ...
19. Fold out the film holder key.
120. Turn the key
2 | holder completely. (Remove the protective slip from the |
| internal battery compartment if necessary) |
21. Place an empty
2122by pushing one end of the spool against the sprung spool retaining arm to engage the stud in the spool end. Position the other end of the spool over the fixed stud in the holder.
Rotate the spool a little if necessary until clicks into position.
22. Completely remove the retaining paper band from a new roll of film and place it in the lower spool holder in the same manner as the empty spool. Ensure you do not place the new film spool the wrong way around! See diagram for correct orientation.
9
