Maintenance
Load Default | To reset the camera to its factory default settings, click “Apply”. Then, |
| follow the instructions on the screen to complete the process. The |
| factory default settings are as follows. |
| Camera Name: “HNC290G” |
| IP Address: “192.168.2.3” |
| Subnet Mask: 255.255.255.0 |
| Administrator Name: “Admin”; Password: “1234” |
| Video Port: “5000”; Web Port: “80” |
Reboot System | To reboot the camera, click “Reboot System” and then click “Apply”. |
LED Light OFF/ON | There are four LEDs to indicate the status of camera. If you want to |
| prevent the camera from being noticed, you can turn off the LED lights |
| by clicking “LED Light OFF” and then clicking “Apply”. To turn on |
| the LED lights, click “LED Light ON” and then click “Apply”. |
Upgrade Firmware | Clicking the “Upgrade Firmware” and “Apply” buttons will lead you to |
| the upgrade page. Select the “*.bin” file and click “Upgrade” to begin |
| upgrading. Note that the camera will stay in upgrade mode until you |
| finish upgrading the firmware. |
|
|
61
