Honeywell 6271V manual How to Display Faults, Security System Operation contd, Screen, Action

Security System Operation (cont'd)

How to Display Faults

The Display Faults function is used when you see a Not Ready Fault message and want to determine were the fault is and what type of fault it is.

To display faults do the following:

1.From the "Home" screen, press the SECURITY button. The "Arming" screen is displayed.

SCREEN	ACTION
	2. From the "Arming" screen, press the
	DISPLAY FAULTS button. The "Display
	Faults" screen is displayed showing a
	listing of faulted and/or bypassed zones.
	The following symbols may be displayed
	on the "Display Faults" screen.
	Zone in alarm
	Zone has trouble
	Zone is faulted
	Zone has low battery
	Zone is bypassed
	3. As applicable, take corrective action
	such as closing a window or door to
	correct the fault. If the fault cannot be
	corrected, you may chose to bypass a
	zone by touching the zone to select it and
	depressing the BYPASS SELECTED
	button or bypass all faulted zones by
	depressing the BYPASS ALL button.
	The "User Authorization" screen is
	displayed with the instructions "To
	Bypass Zones, Enter Code".

•Residential systems will not allow you to bypass fire or emergency zones. On commercial systems, a specified user may be allowed to bypass fire and system zones if the user was enabled by your system installer.

•To bypass zones the system must be disarmed first.

•Limits apply as to how many zones can be bypassed at one time. These limits are ten zones on residential and five zones on commercial systems.

16