Serial Connector

The following diagram displays the pin diagram of the serial connector of the base.

Pin

Description

 

 

 

 

1

Internal Jumper to Pin 6

 

 

2

TXD

 

 

3

RXD

 

 

4

No Connect

 

 

5

GND

 

 

6

DTR

 

 

7

CTS

 

 

8

RTS

 

 

9

RI

 

 

Note: The signal names are referenced to the terminal. The terminal is a DCE RS232 device. Refer to section, RS232 Communications Cables and RS232 Pin Configuration for more details. The base is at a right-angle to the printed circuit board (PCB). The ninth pin has a ring indicator (RI).

Mounting the HomeBase

Set the base on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be sure to provide enough workspace with good lighting for the user to view and operate the Dolphin terminal while it is in the base.

When choosing a mounting location, bear in mind that the location must allow users' easy access to the Auxiliary Battery Well and the back panel of the HomeBase where the serial port, USB port, and the power jack are located.

Desk Mounting

The DIN rail slot (7.5 X 35 mm) may be mounted on the bottom to allow for secure desk attachment of the unit if desired.

Hardware Required

•3/16 in. dia x 5/8 in. long pan head screw

•1/2 in. OD x 7/32 in. ID x 3/64 in. thick

•3/16 in. dia nut

Installing the DIN Rail

Serial and USB port location (not in view)

DIN Rail (7.5 X 35 mm)

1.Slide the DIN rail into the slot along the bot- tom panel of the base.

2.Then, using the appropriate nuts and bolts, secure the DIN rail to the desk or flat surface.

12 - 9