Back Panel

Power Supply Connector

Power Supply Connector

This connector receives input from the power adapter. Plug the power connector cable from the power adapter into this connector.

Power

The terminal requires 12 Volts DC input for battery charging; the power adapter on the power cable converts the voltage from the power source to 12 volts DC. Only the Honeywell 12V/8.5A power supply provided with the Net Base converts the voltage appropriately. The operating temperature range is -10° to 50°C (14° to 122°F).

Honeywell recommends that you leave the ChargeBase connected to its power source at all times, so that it is always ready to use.

!We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the ChargeBase

1.Plug the A/C power cord into the power adapter.

A/C Power Cord

2. Plug the power connector cable into the power connector on the back panel of the ChargeBase.

3.Plug the A/C power cord into a standard wall

outlet. The LED on the Power Adapter illuminates to indicate power.

4.All of the Power/Dock LEDs illuminate red to indicate the base has power. Terminal wells with properly docked Dolphins indicate power with a green LED.

5.The base is ready to begin charging terminals.

LED

Power Adapter

Power Connector Cable

15 - 3