DC Power Jack

Use the power cable from Honeywell that comes with the eBase to supply power to this power jack. For more information, see Power on page 13-5.

Bottom Panel

For details on how to mount the eBase, see Mounting the eBase on page 13-8.

Serial Number Label

MAC Address Label

Compliance Label

Power

The terminal requires 12 Volts DC input for communications and battery charging; the power adapter on the power cable converts the voltage from the power source to 12 Volts DC. Only the Honeywell 12VDC, 3A power supply provided with the ebase converts the voltage appropriately. The operating temperature range is -10° to 50°C (14° to 122°F).

Honeywell recommends that you leave the eBase connected to its power source at all times, so that it is always ready to use.

!We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the eBase

A/C Power Cord

Power

 

Adapter

Power Cable

1.Plug the A/C power cord into the power adapter.

2.Plug the power cable into the power connector on the back of the eBase.

3.Plug the A/C power cord into a grounded power source. The Power/Dock LED on the eBase illuminates solid red to indicate the eBase has power and no terminal is docked.

13 - 5