Honeywell HSVR-04, HSVR-16 user manual Web Client Operation, Parameter, Function

Web Client Operation

Please refer to the following sheet for detailed information.

Parameter	Function
Event Type	There are three types: Motion detection/video loss/Camera
	Masking.
Channel	Select channel name from the dropdown list, and check the
	checkbox beside it to enable its motion detection function.
Sensitivity	There are six levels. The sixth level has the highest
	sensitivity.
	There are six levels. The sixth level has the highest
	sensitivity.
	Region: If you select motion detection type, you can click this
Region	button to set motion detection zone. The interface is shown in
	Figure 6-40. There are PAL 22X18/NTSC 22X15 zones. Right-
	click and you can go to the full-screen display mode. Do
	remember to click OK to save your motion detection zone
	setup.
	Motion detection function becomes activated in the specified
	periods.
	There are six periods in one day. Please check the checkbox
Period	to enable corresponding period.
	Select date. If you do not, the current setup applies to today
	only. You can select all week column to apply to the whole
	week.
	Click OK, and the system goes back to motion detection
	interface; please click Save to exit.
Anti-dither	Not Effective in the current DVR version.
	There is 3-channel alarm output.
	Corresponding to motion detection alarm output port (multiple
Alarm out	choices)
	Enable alarm activation function. You need to select alarm
	output port so that the system can activate the corresponding
	alarm device when an alarm occurs.
Alarm latch	System can delay the alarm output for a specified time after a
	detection event ends. The value ranges from 10s to 300s.
	System auto activates motion detection channel (multiple
	choices) to record once alarm occurs (working with motion
Record	detection function). Please note you need to go to the chapter
channel	Schedule on page 35 to set motion detection record period
	and go to the chapter Manual Record on page 28 to set the
	current period as auto record.
Record latch	System can delay the record for specified time after a
	detection event ended. The value ranges from 10s to 300s.

126