LEAP

To use LEAP (without WPA), make sure the following profile options are used.

1.Enter the SSID of the Access Point assigned to this profile.

2.Set EAP Type to LEAP.

3.Set Encryption to WEP EAP or Auto WEP (depending on SCU version).

4.Set Auth Type as follows:

•If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to Open.

•If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared.

•If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.

5.See Sign-On vs. Stored Credentials (page 11-17)for information on entering credentials.

6.To use Stored Credentials, tap on the Credentials button. No entries are necessary for Sign-On Credentials as the user will be prompted for the Username and Password when connecting to the network.

7.Enter the Domain\Username (if the Domain is required), otherwise enter the Username.

8.Enter the password.

11 - 23