Honeywell MX7 When Cradle LED is …, It means …, Vehicle Cradle Strain Relief Cable Clamps

Vehicle Cradle Strain Relief Cable Clamps

Equipment Required: Phillips screwdriver (not supplied by Honeywell).

There are three strain relief cable clamps secured to the back of the vehicle cradle, located above the ports for the Serial Interface, Power and MX7 I/O connections.

1.Remove the strain relief cable clamp from the back of the cradle by turning the screw counterclockwise. Put the screw aside in a safe location.

2.Slide the strain relief clamp over the cable.

3.Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the vehicle cradle. Do not stretch the cable. Leave enough slack in the cable to allow the cable to be connected and disconnected from the MX7 Tecton easily when needed.

4.Continue in this manner until all cables are secured to the back of the vehicle cradle.

Vehicle Cradle LED

The cradle LED is located at the front center of the cradle.

When Cradle LED is …	It means ….
	MX7 Tecton is docked. Cradle does not have power.
	MX7 Tecton is not docked. Cradle may have power. Check
	the power connector at the back of the cradle.
Off
	MX7 Tecton is docked and external power is connected.

Red

14 - 34