LEDs and Indicators

The Scan Status oval shaped indicator is situated below the keypad and next to the On button.

LEDs (Light Emitting Diodes) are located on the front of the MX7 Tecton. They are:

•System Status LED indicates power management status. It is located at the top left of the keypad, below the F3 key.

•Alpha Mode Status LED applies to the 32-key keypad only. It is located below the F4 key on the 32-key keypad.

System Status LED

Blinking Red

Battery power fail; critical suspend mode.

 

 

Steady Red

Main battery low.

 

 

Blinking Green

Display turned off.

 

 

Yellow / Amber

A few seconds when Power key is pressed.

 

 

No Color

No user intervention required.

 

 

Alpha mode Status LED

Steady Green

Device is in “Alpha” character input mode.

 

 

No Color

Device is in “Numeric” key input mode.

 

 

Scan Status Indicator

Steady Green

Good scan.

 

 

Steady Amber

Decoder engine storing changed parameters.

 

 

Steady Red

Scan in progress.

 

 

No Color

Scanner / Imager ready for use or no scanner installed.

 

 

Toggle Vibrate Indicator

The vibration motor is activated when a scan is completed successfully (good scan vibration) or with a failure (scan key released before good scan, timeout, or rejected because of Data Options configuration). The vibrations can be detected under the handstrap or through the trigger handle.

Vibrate indicator is toggled on and off in the Data Collection application, using the Notification tab. Toggle the vibrate indicator on or off by tapping the desired radio button for Good Scan Vibration and Bad Scan Vibration.

Options are: Off, Short, Medium or Long.

Vibration can also be adjusted by tapping the speaker icon in the top right corner of the Start screen. A Volume window opens. Tap the Vibrate radio button to toggle vibration on and off. Vibration duration can be set using the Data Collection control panels.

2 - 11