Wiring Schematic

Connecting to Vehicle Power

The vehicle cradle must be empty. The last connection must be to the vehicle power source.

1.Connect the power cable to the vehicle cradle.

2.Route the cable from the cradle to the DC/DC power supply.

3.Cut the cable to length and strip the wire ends.

4.Route the power cable the shortest way possible. The cable is rated for a maximum temperature of 105°C (221°F). When routing this cable it should be protected from physical damage and from surfaces that might exceed this temperature. Do not expose the cable to chemicals or oil that may cause the wiring insulation to deteriorate. Always route the cable so that it does not interfere with safe operation and maintenance of the vehicle.

5.Remove the lid from the DC/DC power supply by removing only the screws on the side of the lid.

6.Attach the stripped wire ends to the output side of the DC/DC power supply

.

Note: The input block has VIN+, VIN- and GND terminals. The output block has VO+ and VO- terminals.

7. Connect the ground wire from the cradle to the GND terminal on the input side of the DC/DC power supply.

14 - 30