Connecting the USB Client and Power Cable
Note: AC/DC Adapter must be assembled before this process begins.
Note: Do not connect AC power to the AC Adapter until instructed in the following procedure.
Insert A/C
Connect to Input/Adapter Cable Output Port
Connect to USB
client port
1.Holding the cable I/O connector, pinch the catch release buttons in until the catches are open. Connect the cable to the MX7 Tecton I/O port by matching the shape of the I/O connector on the cable with the shape of the I/O connector at the base of the MX7 Tecton. Release the catch release buttons.
2.Insert the AC adapter single pin cable.
3.Connect the AC Adapter to an indoor power source (wall outlet).
4.Insert the USB client plug into the target USB Client port. The MX7 Tecton and the USB client are connected.
Connecting the Serial and Power Cable
Note: AC/DC Adapter must be assembled before this procedure begins.
Note: Do not connect AC power to the AC Adapter until instructed in the following procedure.
Insert A/C
Connect to Input/Adapter Cable Output Port
Connect to Serial
client port
1.Holding the cable I/O connector, squeeze the catch release buttons in until the catches are open. Connect the cable to the MX7 Tecton I/O port by matching the shape of the I/O connector on the cable with the shape of the I/O connector at the base of the MX7 Tecton. Release the catch release buttons.
2.Connect the AC adapter single pin cable.
3.Connect the assembled AC/DC Adapter to an indoor power source (wall outlet).
4.Connect the RS232 cable end to the desired serial device. Turn the thumbscrews clockwise until the connection is finger- tight. The MX7 Tecton and the serial device are connected.
2 - 21