Initial Setup
The initial setup of ActiveSync must be made via a USB or serial connection. When there is a Connect icon on the desktop, this section can be bypassed.
Partnerships can only be created using direct serial or USB cable connection.
After the partnerships are established, ActiveSync communication can be initiated using:
•USB
•Serial
•Wireless
Connect via USB
The default connection type is USB Client
To change the connection type or to verify it is set to USB, select
Start > Settings > Control Panel > PC Connection
Tap the Change button. From the popup list, choose
USB Client
This will set up the mobile device to use the USB port. Tap OK and ensure the check box for “Allow connection with desktop computer when device is attached” is checked.
Tap OK to return to the Control Panel. If desired, any control panel windows may be closed.
IMPORTANT – DO NOT PUT THE MOBILE DEVICE INTO SUSPEND WHILE CONNECTED VIA USB. The device will be unable to connect to the host PC when it resumes operation.
Connect the correct cable to the PC (the host) and the mobile device (the client) as detailed below. USB will start automatically when the USB cable is connected, not requiring you to select “Connect” from the start menu.
Cable for USB ActiveSync Connection:MX7052CABLE - MX7 Charge/Comm Interface Cable with USB Client port for ActiveSync. USB end of cable connects to PC/Laptop USB port.
•Connect the MX7 end of the cable to the I/O port on the bottom of the MX7
•The USB type A connector on the cable connects to a USB port on a PC or laptop.
•It is not necessary to connect the power connector on the cable in order to use ActiveSync.