Honeywell VISTA-40, 2-Partitioned Security System manual Table of Contents

Table of Contents

Recommended Programming Procedure	3	Device Programming	21
Program Field Index	4	Relay Programming	22
VISTA-40 Programming Form	5	Relay Voice Descriptors	25
Partition-Specific Fields	9	Relay Voice Descriptors and Custom Word
Programming With #93 Menu Mode	10	Substitutes Vocabulary	26
		Custom Word Substitutes for VIP Module
Zone Programming	11
		Annunciation	26
5800 Series Transmitters Loop Designations	13
		System Layout Worksheets	27
Expert Mode Zone Programming	14
		Relay Outputs Worksheets	33
Alpha Descriptors Programming	17
		VISTA-40 Summary of Connections Diagram	35
Alpha Descriptor Vocabulary	20

The purpose of this document is to provide a quick and easy way to program your entire system. A recommended programming procedure is included, followed by a list of program fields with the corresponding program group they belong to (system-wide, partition-specific, scheduling, etc.). Two program forms are included. One contains all the programming fields, and the other contains the partition-specific fields. If you are setting up a single-partition system, the partition-specific fields become system-wide fields.

Following the program forms are system layout worksheets. We recommend that you use these sheets to plan your system before programming is performed. If you need further information about specific programming options, see the ADEMCO VISTA-40 Installation and Setup Guide.

Make sure that one two-line alpha keypad is connected to the control and is set to device address "00."

Single-Partition System

The system default is for a single-partition system. Use the VISTA-40 SINGLE PARTITION PROGRAMMING FORM when programming for single-partition usage. Follow the steps outlined in RECOMMENDED PROGRAMMING PROCEDURE of this document for proper programming procedure.

Multiple-Partition System

You must enter the number of partitions you are using in data field 2*00 to set the system for multiple partitions. Use the VISTA-40 SINGLE PARTITION and the PARTITION-SPECIFIC PROGRAM FORMS when programming the system for multiple partitions. Follow the steps outlined in RECOMMENDED PROGRAMMING PROCEDURE of this document for proper programming procedure.

SUMMARY OF PROGRAMMING COMMANDS

•To enter program mode, enter installer code + [8] + [0] + [0]

•To set standard defaults, press ✱97

•To change to next page of program fields, press ✱94

•To return to previous set of fields, press ✱99

•To erase account and phone number field entries, press [✱] + field number + [✱]

•To assign zone descriptors, press #93 + follow menu prompts

•To add custom words, press #93 + follow menu prompts

•To enter Installer's Message, press #93 + follow menu prompts

•To exit program mode, enter ✱99 OR ✱98: ✱99 allows re-access to programming mode by installer code. ✱98 prevents re-access to programming mode by installer code.

Standard default (✱97) values are shown in brackets [ ], otherwise default = 0.

– 2 –