A S S E M B LY STEP 1
INTRODUCTION
CONSOLE MAST
CONSOLE MAST BOOT
TOP CAP
A)Open HARDWARE BAG FOR STEP 1.
| WAVY WASHER (D) |
| FLAT WASHER (C) |
| SPRING WASHER (B) |
| BOLT (A) |
CONSOLE WIRE | MAIN FRAME |
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
B)Slide the CONSOLE MAST BOOT followed by the TOP CAP over the CONSOLE MAST.
C)Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D)Attach the sides of the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).
E)Attach the front of the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (A), 2 SPRING WASHERS (B) and 2 WAVY WASHERS (D).
F)Slide CONSOLE MAST BOOT down to seal the console mast hole.
HARDWARE BAG FOR STEP 1 CONTENTS :
BOLT (A) | SPRING WASHER (B) | FLAT WASHER (C) | WAVY WASHER (D) |
15 mm | Qty: 6 | 20 mm | 17 mm |
Qty: 6 |
| Qty: 4 | Qty: 2 |
|
|
| angle view |
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
