Lenovo 3093AC6 manual Numeric error codes

Numeric error codes

Table 2. Numeric error codes

Symptom or error	FRU or action, in sequence
0175	System board.
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
0176	1.	Run BIOS Setup Utility, and save the current
System Security—The system has been tampered with.		setting by pressing F10.
	2.	System board.
0177	System board.
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0182	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad CRC2. Enter BIOS Setup and load Setup		load the default setting. Then save the current
defaults.—The checksum of the CRS2 setting in the		setting by pressing F10.
EEPROM is not correct.	2.	System board.
0185	1.	Run BIOS Setup Utility. Press F9, and Enter to
Bad startup sequence settings. Enter BIOS Setup and		load the default setting. Then save the current
load Setup defaults.		setting by pressing F10.
0187	System board.
EAIA data access error—The access to EEPROM is failed.
0188	System board.
Invalid RFID Serialization Information Area.
0189	System board.
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190	1.	Charge the battery pack.
Critical low-battery error	2.	Battery pack.
0191	1.	Run BIOS Setup Utility, and then save current
System Security—Invalid Remote Change requested.		setting by pressing F10.
	2.	System board.
0192	System board.
System Security— Embedded Security hardware tamper
detected.
0193	Enter the BIOS Setup Utility supervisor password.
RF antenna has been removed
0194	Enter the supervisor password.
The computer has been carried through a security gate
0195	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware tamper detected		password, and select Password ➙ Security Chip
		➙ Clear Security Chip ➙ to clear this error.
	2.	Security chip.
	3.	System board.
0196	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware removed		password, and select Password ➙ Security Chip
		➙ Clear Security Chip to clear this error.
	2.	Security chip.
	3.	System board.
0197	The remote configuration for the security chip has
Invalid remote change requested.	failed. Confirm the operation and try again.

Chapter 4. Related service information 51